Fisher & Paykel OR24SDPWGX1 Guía de instalación Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
15
SETTING THE BURNER MINIMUM
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
– Light the burner
Set the gas valve to
LO position
– Remove the knob
With a thin screwdriver pass by the hole of microswitch and turn the screw F until
adjustment is correct (fig. 2.13).
For LP/PROPANE gas, tighten the adjustment screws completely.
After regulation repeat the operations indicated in paragraph “2. Pressure regulator” at
page 9 and 12. If the range has been disconnected and then connected again to the gas
supply line repeat the operations indicated in paragraph “5. Leak Testing” at page 12.
IMPORTANT:
After conversion to LP/PROPANE gas has been carried out affix on the back of the
appliance, near the data plate, the conversion label supplied and also affix a conversion
label at page 3 of this instruction manual.
Fig. 2.13
OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING
THE INJECTORS
Remove the gratings, the burner covers and the knobs;
Using a wrench substitute the nozzle injectors “J” (figs. 2.11 - 2.12) with those most
suitable for the kind of gas for which it is to be used.
The burner are conceived in such a way so as not to require the regulation of the
primary air.
INJECTORS TABLE
NOMINAL
POWER
REDUCED
POWER
LP/PROPANE
11” W.C.P.
NATURAL GAS
4” W.C.P.
BURNERS
BTU/hr BTU/hr
Ø injector
[1/100 mm]
By-pass
[1/100 mm]
Ø injector
[1/100 mm]
By-pass
[1/100 mm]
Auxiliary (AUX)
3500 1000 55 27 90
adjustable
Semirapid (SR)
6000 1500 72 32 118
adjustable
Triple ring (TC)
12000 5000 102 65 170
adjustable
Fig. 2.11
J
F
Fig. 2.12
J
2
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comentarios a estos manuales

Sin comentarios