Fisher-paykel GC901M Manual de usuario descargar pdf (Pagina 20)

PROBLEM SOLUTION

My cooktop does not Check it is plugged in and there is power to the wall

light socket.

The gas ignites may be dirty. These can be easily cleaned

with a toothbrush and rubbing alcohol.

The burner parts may not be located properly. Check the

assembly and make sure the burner cap is sitting flat.

Check the gas supply valve is turned on and the supply to

the house is working.

My burner flames are The burner parts may not be located properly. Check the

yellow/slow to start assembly and make sure the burner cap is sitting flat.

If you use bottled gas this may indicate you are getting

near the end of the bottle.

Check that the burner parts are not clogged or blocked

with water.

The gas pressure may not be at the correct level, check

with your installer.

One of my burners Check the burner parts are assembled correctly and that

has an uneven flame the burner cap is sitting flat on the burner.

My cooktop is Your cooktop thinks that the flame has gone out. This

sparking could be unnecessarily caused by drafts disturbing the

flame.

Check that the igniter is clean and dry.

Your power supply may not be properly grounded, or, in an

older house the correct wiring polarity may not have

been observed.

The flame goes out at Gas supply pressure may be low, check with service

low settings person/installer.

Low setting may have been adjusted incorrectly, check

with your installer.

TROUBLE SHOOTING

1 2 ... 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Fisher-paykel GC901M Manual de usuario Pagina 20