Fisher Paykel OR30SDPWIX2 Manual de usuario Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
32
Using your induction cooktop
Control dials
Each cooking zone is activated by a separate control dial positioned on the control panel. The
functions are arranged on the actual dial itself.
If a cooking zone is not turned off (OFF position) the electronic system automatically switches
it off after a pre-set time ranging from 90 minutes to 520 minutes, depending on the power
setting.
Power level
Push the dial in and turn it clockwise to set the temperature between Very Gentle heat and
9 (maximum).
The power level can be modified at any time by turning the dial clockwise or counter-clockwise
to a different setting.
The cooking zone display shows the selected level.
Hot Surface Indicator
When the temperature of a cooking zone is still hot, the relevant Hot Surface indicator lights
up on the display to alert you of the hot surface. Avoid touching the cooktop surface over the
cooking area. Please pay special attention to children. When the
is lit on the display, it is
still possible to start cooking again; just turn the control dial to the required power level. The
indicator will disappear when the surface has cooled down to a safe temperature.
Childlock
You may lock all of the cooktop. Ensure the cooking zones are turned OFF.
Push and turn the left cooking zones dials to the left (‘A setting) and hold the dials down
until the
lights up on the cooking zone displays (on the left cooking zones displays,
lights up after
); then release the dials after the beep.
After a few seconds the
will go out, but the cooktop remains locked.
To deactivate the childlock repeat the same procedure until the
goes out (and
after the
beep).
If you try to turn a cooking zone on while locked the
will show in the display. The
will
remain lit until the dial is turned back to OFF. If you try to set the Auto Heat-reduce feature
(‘A
setting) on a cooking zone
while locked, nothing will be shown in the display and the feature
will not be set.
1
2
1
2
3
4
5
6
7
8
9
Control dial
US
CA
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Comentarios a estos manuales

Sin comentarios